Flash your ESP from the browser
Free tool. Your files never leave your computer — they go straight from the browser to the chip over USB.
1 · Connect
2 · Files
Advanced flash settings
Leave on keep unless you know you need to change them. “keep” writes your files exactly as they are.
3 · Program
Log
Which address do I use?
| File | ESP32 / ESP32-S2 | S3 / C2 / C3 / C6 / H2 / ESP8266 | C5 / P4 |
|---|---|---|---|
Complete / merged image (*.merged.bin, factory.bin) | 0x0 | 0x0 | 0x0 |
bootloader.bin | 0x1000 | 0x0 | 0x2000 |
partitions.bin | 0x8000 | ||
boot_app0.bin / ota_data_initial.bin | 0xE000 | ||
Your program (*.ino.bin, firmware.bin) | 0x10000 | ||
Trouble connecting?
- Use a USB data cable (many cables are charge-only).
- Install the USB driver for your board: CP210x or CH340/CH341.
- Hold the BOOT button, click Connect, then release it once connected.
- Close Arduino IDE, Serial Monitor or anything else using the port. Try a lower baud rate.